Top Ad unit 728 × 90

random

How to Assembly of the Knot Type Rope Socket

This article will talk about how to assembly knot type slickline Rope Socket, this is the most important thing for slickline operator. Because with out making the rope socket, slickline operator can't do their job.

How to assembly of the Knot Type slickline Rope Socket before slickline Operation.

[post_ad]
After rig up and make up slickline PCE, slickline operator have to make a new knot of rope socket. This is the preparation and step by step procedures to assembly the Knot Type slickline Rope Socket :
Holding the wire taut, start bending the wire about the disc
Illustration, doc. IndustriMigas

  • Pass the end of the wire through the stuffing box and then pass the end of the wire through the slickline Socket body, spring and spring support.
  • Place the disc in a vice and run the wire down between the jaws behind the disc, then bend the end of the wire into a loop to form a handle that will be comfortable to grip. The disc should contact the wire approximately 10 in. to 12 in. from the loop.
  • Grip the long end of the wire (the end connected to the drum) by wrapping it around your left fore arm (I fright - handed) and the handle with your right hand.
  • Holding the wire taut, start bending the wire about the disc(a). The wire should go around the disc once, then be wrapped around it self making sure the reps a minimum of slack in the wire when starting to wrap. These wraps should be made smooth and even and should hug the wire closely with the coils touching one another.
Continue wrapping in this manner until about 12 coils are made. Move the wire in the direction shown in order to twist off the free end
Illustration, doc. IndustriMigas

  • Continue wrapping in this manner until about 12 coils are made. Move the wire in the direction shown in order to twist off the free end (b). Be careful to keep the loop pointed in the same direction or slightly twisted during this part of the operation, so that the torque is focused on the end of the last coil. The wire should twist off (c). Place the disc cross wise in the vice or pliers and straighten the Knot as well as possible.
The Socket is now ready to be attached to the upper end of the stem
Illustration, doc. IndustriMigas

  • Now using the wire, pull the Knot into the socket and check to see that the socket swivels freely.
  • The Socket is now ready to be attached to the upper end of the stem.
How to Assembly of the Knot Type Rope Socket Reviewed by Arief Dermawan on 10:46 AM Rating: 5

No comments:

Thank you for visit and read this post. Share this post if you like it.
Leave your comment on this text box

All Rights Reserved by IndustriMigas | #1 Oil and Gas Blog © 2014 - 2015
Powered By Blogger, Designed by Sweetheme

Contact Form

Name

Email *

Message *

www.industrimigas.com. Powered by Blogger.